AirLink Communications RJ-11 Bedienungsanleitung PDF herunterladen (Seite 5)

AirLink Communications March 2007 5

Connecting to a RADES Over Cellular Networks with AirLink Devices

FIGURE 4. Wireless Ace: Status

B. Note the IP address listed in the Va l ue column for the command *NETIP.

For *NETSTATE, “Network Ready” means your modem is connected on the cellular network and

waiting for connections. “Network Dormant” means the modem is connected and waiting for con

nections but the connection has been idle. In either state, the modem is ready for the steps in the

next section.

Configuring the IP Address and Interface Port of the RJ-11 IP

Gateway

RJ-11 IP Gateway Defaults

• Phone port: 7 data bits, even parity, and 1 stop bit (7E1).

• Protocol: American/Bell 212A.

• Maximum baud: 2400.

• DHCP client: enabled.

Configuring the RJ-11 IP Gateway

FIGURE 5. Web Browser : Enter the Location

Disconnect your modem’s Ethernet cable from your computer, but leave the modem connected to

power so it remains on the cellular network.

Connect the RJ-11 IP Gateway to power and connect the Ethernet cable from your Raven X to the

RJ-11 IP Gateway.

Type “http://”, the IP address from the modem, and “:9080” (see the example in the screenshot

below) in the Address or Location bar and press the enter key.

http://166.213.236.221:9080

1 2 3 4 5 6 7 8 9 10 ... 15 16

Keine Kommentare

AirLink Communications RJ-11 Bedienungsanleitung Seite 5